Button Cover for Midea Cube 20 Pint / 12L Dehumidifier
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Button cover to stop accidental settings changes/button presses on Midea Cube 20 Pint Dehumidifer. Friction fit.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 1
- Wyświetlenia
- 179
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I got sick of my cat, Zeus, sitting on the dehumidifier and changing the settings. The Midea Cube (we have two) doesn't have a way to lockout the button controls.
This cover goes over all of the control buttons, while still allowing access to them and quickly being ale to see the status lights. Friction fit on the lid, it's not super tight but it's enough to keep the cat from messing with the settings. This was designed for a Midea Cube 20 pint dehumidifier. If the link breaks, it is Midea Model MAD20S1QWT, UPC = 810040941528
(Per feedback from Freemanowe, it fits the 12L version as well)
I printed this on my Ender 3 Max Neo, 300x300mm build plate, and it fit diagonally. This is possible to fit on a 256x256mm build plate as shown in the screenshot - you just have to rotate it carefully till the error goes away. I am very new to modeling so maybe at some point I can make a version that prints in multiple parts for smaller printers.
Make sure you flip it upside down when printing - then it requires no supports.