1 / 14
Pulse XE Dual Gantry belt tensioner — zdjęcie 1
1 / 14

Pulse XE Dual Gantry belt tensioner

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Alternate belt tension system for the single motor gantry lift

Ocena
0 / 5
Polubienia
3
Pobrania
13
Wydruki
0
Wyświetlenia
111
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A new belt tension system for the single motor dual z axis gantry lift system I created. 

Two 3D model parts printed and put together with 4 Dragon 608 flanged bearings. Mounts to inside and outside of the 3030 frame with M4 screws and snap in t-nuts. 70mm of 8mm hard chrome bearing shaft is used with a 20 tooth 6mm pulley to keep the 2GT belt around the drive pulley, maximizing contact. 

I had to slow down the Z axis acceleration and movement due to belt slippage. This tensioner eliminates that problem. Allows high speed Z-Hop and 110 point bed leveling in under 60 seconds. 

ABS/ASA 0.2LH, 6 walls, 1.5mm shells, 50% Adaptive Cubic

[Updated 7-02-2025] Lowered left mount down under the belt

Original project here:

https://www.printables.com/model/1056670-single-motor-gantry-lift-system

 

Tagi