Pulse XE Dual Gantry belt tensioner
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Alternate belt tension system for the single motor gantry lift
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 13
- Makes
- 0
- Views
- 111
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A new belt tension system for the single motor dual z axis gantry lift system I created.
Two 3D model parts printed and put together with 4 Dragon 608 flanged bearings. Mounts to inside and outside of the 3030 frame with M4 screws and snap in t-nuts. 70mm of 8mm hard chrome bearing shaft is used with a 20 tooth 6mm pulley to keep the 2GT belt around the drive pulley, maximizing contact.
I had to slow down the Z axis acceleration and movement due to belt slippage. This tensioner eliminates that problem. Allows high speed Z-Hop and 110 point bed leveling in under 60 seconds.
ABS/ASA 0.2LH, 6 walls, 1.5mm shells, 50% Adaptive Cubic
[Updated 7-02-2025] Lowered left mount down under the belt
Original project here:
https://www.printables.com/model/1056670-single-motor-gantry-lift-system