ID - Card Holder Keyring Edition
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
ID-Card Holder to attach it to a keyring
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 64
- Wydruki
- 1
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update
Created three new versions!
Widened Eyelet
3.5mm inner dimension instead of 3mm as my keyring was not able to rotate freely.
Keyring Edition - Double Sided
To allow ID Cards to be visible from both sides
Classic - Double Sided
Classic but also double sided in difference to the original model from @laisch
Print instructions
Suggest grid support everywhere for the new models as easiest to remove afterwards.
Suggest to print in 0.15mm for a clean result.
Infill as for the original model. (high or even 100%)
Original Version
Got a nice but flat lanyard that has a keyring instead of the usual swivel hook or ID strap clip.
Therefore I had to rotate the hole by 90° degrees.
Fits standard 86x54mm key cards.
Print instructions
Must be printed with supports (enable supports on print plate only).
Suggest organic support for the original model.
Suggest to print with a bit higher infill or even at 100%.