ID - Card Holder Keyring Edition
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
ID-Card Holder to attach it to a keyring
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 64
- Makes
- 1
- Views
- 260
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Update
Created three new versions!
Widened Eyelet
3.5mm inner dimension instead of 3mm as my keyring was not able to rotate freely.
Keyring Edition - Double Sided
To allow ID Cards to be visible from both sides
Classic - Double Sided
Classic but also double sided in difference to the original model from @laisch
Print instructions
Suggest grid support everywhere for the new models as easiest to remove afterwards.
Suggest to print in 0.15mm for a clean result.
Infill as for the original model. (high or even 100%)
Original Version
Got a nice but flat lanyard that has a keyring instead of the usual swivel hook or ID strap clip.
Therefore I had to rotate the hole by 90° degrees.
Fits standard 86x54mm key cards.
Print instructions
Must be printed with supports (enable supports on print plate only).
Suggest organic support for the original model.
Suggest to print with a bit higher infill or even at 100%.