JST-XH 2-pin boot for male connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
JST-XH 2-pin boot for male connector for use making inline connections for fans, thermistors, battery packs, etc.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 476
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
JST-XH 2-pin boot for male connector for use making inline connections for fans, thermistors, battery packs, etc. I could only find male 2-pin JST-XH connectors as pigtailed assembled connectors, which meant I'd have unnecessary additional splices in my wires for my application (3D printing). I made this to use a standard PCB mount JST-XH 2-pin header and convert it to inline. I printed in PLA, but PETG/ABS and maybe even TPU would work. Step file is included in case you wish to modify for your needs.
To use, insert your wires, being careful to note the end state orientation (pins are offset and thus the connector will only go inside one way) and ensure you have correct polarity. Solder your JST connector on, then fill the end of the boot with hot glue and press the JST connector down into it. After it cools and hardens, clean off excess with an x-acto knife.