1 / 2
80mm Fan Holder for Icom IC-706MKII — zdjęcie 1
1 / 2

80mm Fan Holder for Icom IC-706MKII

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A custom 3D printed 80mm fan holder for the Icom IC-706MKII

Ocena
0 / 5
Polubienia
1
Pobrania
20
Wydruki
0
Wyświetlenia
216
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

80mm Fan Holder for Icom IC-706MKII

This is a custom 3D printed fan holder for the Icom IC-706MKII, designed to mount a standard 80mm fan for improved airflow and cooling. It's printed in PETG for strength and heat resistance, ideal for long operating sessions.

The holder attaches using a round magnet — no screws or modifications needed. Three versions are included to fit different magnet sizes:
5mm, 8mm, and 10mm diameter, all with a max depth of 2mm.

🔌 Power Options:

You can power the fan in two ways:

  • With an external 12V power supply, or
  • From the autotuner Molex port on the IC-706MKII:
    • Pin 3 = +12V
    • Pin 4 = GND

A standard 4-pin Molex male connector from a PC PSU works — just trim one side of the plastic to fit the radio's socket.

⚠ Warnings:
  • Do NOT exceed 1A current draw from the Molex port — this is the safe limit for the internal circuitry.
  • Check polarity carefully before connecting — reverse polarity may damage the radio.
  • Ensure your fan's startup current is below 1A, not just the running current.
  • Avoid short circuits — insulate any exposed wires or terminals properly. A short can instantly damage the radio.

Quick to install, easy to remove, and a practical upgrade to keep your IC-706MKII cool and protected.

---

The STEP file is available for download if you want to remix or adapt it.
 

Tagi