Razor MX350 Front Fender
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is a remix from link below. I liked the way the Sur-Ron front fender looked also didn't feel like spending $30 on the mx350 plastic, so I resized it to fit the mx350 and added a hole for the bolt. I made two my first attempt came out a bit small in my opinion (third pic) and the second one was bigger fitting better (first pic). For reference the small is 6in(L) x 3in(W) the bigger one is 8in(L) x 5in(W). I'm new to editing and i am not the best at it, i know there is more that could be done to better fit, that being said, if you edit this send me a link also so i can use the new part you make haha.
Print Settings
Printer Brand:
Voxelab
Printer:
Aquila X2
Rafts:
Yes
Supports:
Yes
Notes:
Was able to print both vertically with no support going to the top, just some support at the bottom just make sure that the bottom is flat on the bed. Use support blockers too. I will insert a photo to show what i mean. Was able to print in 4 hrs using a fast mode profile on cura.
Category: 3D Printing