1 / 3
LiPo Microfit 3 Balance Connector Cap (Up to 12S, 14S) — zdjęcie 1
1 / 3

LiPo Microfit 3 Balance Connector Cap (Up to 12S, 14S)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Cap that prevents the LiPo balance connector from dangling/getting snagged when not in use. Designed for 25mm/1in straps

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
84
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I made this cap/protector that is held in place by 1in/25mm velcro strap on a LiPo pack. I prevents the balance connector (Microfit 3.0, 16P) from dangling and getting snagged when not in use. 

This is perfect for RC helicopter (true) 12S or 14S stick packs!

Print Instructions

  • I used 98A TPU with 100% in-fill. Should work with other filaments as well.
  • With TPU you have to print the model flat with supports. More rigid filaments might allow you to print upright (tall orientation) without supports.

Tagi