Toilet Hinge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A toilet hinge that could have been slow closing, but works as a simple hinge instead.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 75
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Notice: published a new v2 model printable with a 0.4mm nozzle and less failure points
This toilet hinge should be compatible with some IdealStandard models. I just measured my broken piece and turned it into a 3D Printable model.
This model is print in place and in order to print it, you absolutely need:
- 0.2mm nozzle
- Calibrated printer
- Calibrated PETG profile
- Good bed adhesion
Do not bother printing with PLA or using a 0.4mm nozzle.
You want this piece as strong as possible.
I printed it in PETG with these settings (YMMV):
- 18 wall loops
- 50% 3D Honeycomb infill
- Manual support only under the outer arm (everything else is print in place and should break off with a slight rotation)
- Slow speed (you will find it when tuning your PETG profile)
- Thick external bridges
- Detect overhangs
For remixers: inside this model you will find a planetary gearbox, it should supposedly create a bit of friction to slow close the toilet. In reality I made the gears too loose and there isn't friction at all