Phillips Avent bottle to Medela adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adapter for Phillips Avent bottles to Medela accessories
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Public Domain
A simple adapter such that Phillips Avent bottles can be used with Medela accessories.
We are deep in the Phillip's ecosystem for bottles, pumps and accessories, but our newest little one required some extra help during feedings; Phillips does not have anything similar to Medela Supplemental Nursing System so I whipped up this adapter so we could use Phillips bottles straight from the pump. Even the original Phillips bottle caps fit!
Medela Supplement Nursing System and bottle caps fit snugly and perfect with this, so I expect that collars and teats fit as well.
Print with ASA/ABS, 100% infill, 0.12 layer height.
Precautions if you want to use this
- Supports are needed for the internal threads facing the build plate. Everything else prints fine without supports.
- The Phillips bottle mates with the inside of the adapter, blocking liquids from reaching the threads and any such hard-to-clean areas. After you print test for leakages with both a bottle and a Medela cap. Only the internal upper most section of the funnel should be wet.
- If liquid escapes through to Medela external threads it's not critical, but I'd considered reprinting it slightly rescaled if possible.
- If liquid escapes through to Medela external threads it's not critical, but I'd considered reprinting it slightly rescaled if possible.
- Print only with ASA/ABS for sterilization. PETG or PLA will not survive
- Preferably use only white for this print. Definitely do not print with yellow like in the photos. If grime accumulates, you will want to spot it.
- Inspect, clean thoroughly and sterilize before first use. Check for stringing and loose support bits.
- Have a good look at the inside. Ensure you have good layer adhesion and the internal funnel is no less than perfect.
- Both threads have a lot of play and you can achieve a perfect seal even with mangled or droopy threads. Print hotter / slower / less cooling if you are worried about layer adhesion.
- Be worried about layer adhesion.
- Consider if this is worth the risk you will be exposing your little one to; how much is one bottle worth? $10? Only go for this if you trust your printer and prints.