1 / 5
Betafpv Pavo Femto O4 Drone Case — zdjęcie 1
1 / 5

Betafpv Pavo Femto O4 Drone Case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Compact Case with Lipo Battery Housing and props holder for the O4 Version of the Betafpv Pavo Femto Drone

Ocena
5 / 5
Polubienia
13
Pobrania
173
Wydruki
2
Wyświetlenia
616
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

While I made this model completely from scratch, credit where credit is due. I got the inspiration from this particular model: https://www.printables.com/model/1231690-betafpv-pavo-femto-storage-femto

The previous one was sized for 450mAh batteries and it did not fit my 550 ones. The fit was also a bit loose and the drone would bounce around a bit too much for my taste.

I also used the clips from another project: https://www.printables.com/model/39729-tool-box-parametric

I suggest you cut a piece of the thinner foam from the original box and glue it to the inside of your cover like I did for extra protection.

 

This case will fit:
4x 550mAh BetaFPV Batteries (tattu 550 and 450 ok as well)
1x Set of replacement 1611 40mm props

I printed it in Polymaker ASA with 4 Walls and 25% Gyroid Infill

 

Tagi