AC Power Splitter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Power Splitter - 1/2 to 4. Power (AC) Kettle cord splitter
- Ocena
- 0 / 5
- Polubienia
- 44
- Pobrania
- 4124
- Wydruki
- 0
- Wyświetlenia
- 5919
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
AC Power Cord splitter (Kettle Cord) mk1
This was part of my 3D Printer enclosure projects to tidy up the cables on the back of the enclosure.
Uses a standard ‘chocolate bar’ electrical connector
This design comes with:
The body of the splitter
clip-on top (screwless)
a cable-hole top that can be screwed on (3M).
a hole plug in case you don't need all 4 extensions.
Cable hole diameter: 7mm
Blender 4.2 Used.
Note: I tried printing this with ABS first. However it's -7 degrees (C) outside so it warped. I had little patience so I printed it instead with PLA+ (the print in photo). ABS printed better (except for the warp) but, I think it might have something to do with the print settings not being adapted to the new enclosure yet - I will play with the settings a bit more. Anyway: PLA worked fine although I still believe ABS would be better.