1 / 11
Fix for robot vacuum cleaner Vorwerk Kobold VR100 dust compartment detection push-button — zdjęcie 1
1 / 11

Fix for robot vacuum cleaner Vorwerk Kobold VR100 dust compartment detection push-button

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fix for robot vacuum cleaner Vorwerk Kobold VR100 dust compartment detection push-button with broken snap lugs.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
78
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Snap lugs in the tray of the dust compartment on a Vorwerk Kobold VR100 vacuum cleaner robot were broken, so it was not possible to use the cleaner anymore, which was otherwise still working fine.

There are no official solutions and it's not possible to get parts for this old vacuum cleaner robot  anymore (Vorwerk Kobold VR100 vacuum cleaner was sold until beginning of 2016). Therefore a solution was required.

Taping down the dust compartment was working sometimes, but sometimes not.

Design

The snap lugs can not be repaired or replaced, the only possibility was to keep the switch pressed down even the dust compartment was loose.

A thin strip was designed that is screwed on and pushes the button down. To add as little height as possible, pads were needed for a screw insert.

The strip is only 0.7 mm height, therefore a rigid material is required.

Printing

Weight is less than 1 gram, print time is negligable.

Printing in PLA or a material with more stiffness (e.g. PLA-CF) is recommended. PETG is way to soft.

Nozzle 0.4 mm, Layer height 0.2 mm, support on print plate, no brim, no infill.

The easiest way to remove the support is to insert the screw from the underside and push the support out of the part.

 

-------------------------------
The only reward for a hobbyist is likes.

Support / Donation for my work

Tagi