Ender 3 V3 SE LCD support with Raspberry 3B enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Support for the stock LCD panel, with a bottom compartment for a Raspberry PI 3B
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 106
- Wydruki
- 3
- Wyświetlenia
- 651
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
This is a new support for the stock LCD panel, with a bottom compartment for a Raspberry PI 3B. It's fixed to the printer using the original LCD mount screws.
I've been looking for an enclosure for RPI3+LCD but couldn't find any, so I made my own.
Thanks to @tomvdbroek, @jegi and @hugopnabais for their designs. I used part of their geometry to mix it up and create my enclosure.
Details
The top part orientation has been designed to minimize the amount of support needed, I strongly suggest you print it face down, like shown in the picture. Tolerances are tight, so depending on your printer's settings and filament you may need to press a bit to get the lid to close or the LCD to attach.
Don't mind the quality of my print, I'm using a crappy filament and I'm not that good at calibrating it.