1 / 4
1,25" eyepiece to T2 (M42x0.75) thread adapter (short version) — zdjęcie 1
1 / 4

1,25" eyepiece to T2 (M42x0.75) thread adapter (short version)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

1,25" eyepiece to T2 (M42x0.75) thread adapter (short version)

Ocena
0 / 5
Polubienia
3
Pobrania
29
Wydruki
0
Wyświetlenia
102
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Note: This model has been updated. See: https://www.printables.com/model/1508496-adapter_125_eyepiece_to_t2-recapitulation-and-upda

1,25" eyepiece to T2 (M42x0.75) thread adapter (short version)

This new adapter is the one I use with the filter wheel: https://www.printables.com/model/535136-manual-filter-wheel-9-x-125

It is a reduced version of the model: https://www.printables.com/model/331146-125-eyepiece-to-t2-thread-adapter#preview.YF9k1

It is advisable to print the T2 thread (M42x0.75) with a layer height of less than 0.2 mm. I have used, with good results, 0.15 mm layer height, although it can be reduced more. The rest of the part can be printed with 0.2 mm. See settings.Recommended material PETG.

It can be printed without support material.

With a quality filament (PETG prusament) and a good maintenance of the printer, you should not have any problem to print the fine pitch thread.

You will have to insert two M4 DIN934 nuts, before going over the 4 mm holes with a drill.

 

I hope you find this new adapter useful if you use it!!!

 

Modifications compared to the original model:

- I have reduced the height of the adapter to gain focusing travel. 

- I reduced the inner diameter to 31.9 mm to better center the eyepiece.

- I have increased the distance of the brake bolts on the outer line to 8 mm.

 

Original: 

New version:

Tagi