1 / 3
Citroen Xsara Picasso window clip (clip fenêtre) — zdjęcie 1
1 / 3

Citroen Xsara Picasso window clip (clip fenêtre)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Small clip for windows to keep the glass on the rails / Agrafe pour le maintien de la fenêtre dans le rail

Ocena
0 / 5
Polubienia
0
Pobrania
16
Wydruki
0
Wyświetlenia
99
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
GNU General Public License v3.0

EN

Window clip designed for Citroën Picasso Xsara 2005, may work with other variants. I recreated the model based on a scan, so the dimensions are not exactly the same.

This clip holds the window in place when you open/close it. I've had a few symptoms with my driver's window, such as it dropping down and then gradually rising up, and not closing properly... it was this clip that was broken (there are 2 per window from what I've seen). To access the clip, you have to go through the window mechanism and remove the door trim.

Printed with a CR10 V2, using Prusa profiles and Prusa slicer with 0.12mm DETAIL profile & 0.4mm nozzle. In the picture I used PETG but for a car you may want to use a different material more heat resistant. 

/!\ Use at your own risk. The safety and properties of the part have not been tested in a real environment (e.g. a car accident).

FR

Clip de vitre conçu pour Citroën Picasso Xsara 2005, peut peut-être fonctionner avec d'autres variantes. J'ai recrée le modèle en me basant sur un scan, donc les dimensions ne sont pas exactement les mêmes.

Ce clip maintient la vitre en place lorsque vous l'ouvrez/fermez. J'ai eu quelques symptômes avec ma vitre conducteur comme le fait qu'elle baissait puis remontait petit à petit, qu'elle ne se fermait pas bien… il s'agissait de ce clip qui était cassé (il y en a 2 par fenêtres de ce que j'ai vu). Pour accéder au clip il faut passer par le mécanisme de la fenêtre en démontant la garniture de la porte.

Imprimé avec une CR10 V2, en utilisant le slicer Prusa et le profile Prusa en 0.12mm DETAIL et une buse de 0.4mm. Sur les photos j'ai utilisé du PETG mais il vaut mieux utiliser un matériaux plus résistant à la chaleur.

/!\ Utilisation à vos risques et périls. La sécurité et les propriétés de la pièce n'ont pas été testées dans un environnement réel (par exemple, un accident de voiture).

Tagi