1 / 3
Z offset First layer test calibration eneagon print 50mm, 75mm, 100mm and all corners for 0.2mm layer height — zdjęcie 1
1 / 3

Z offset First layer test calibration eneagon print 50mm, 75mm, 100mm and all corners for 0.2mm layer height

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

First layer test to adjust z offset for perfect first layer for 0.2mm layer height

Ocena
0 / 5
Polubienia
4
Pobrania
141
Wydruki
0
Wyświetlenia
336
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
GNU General Public License v2.0

This test model matches a standard first layer height (0.2 mm) and helps fine-tune your Z-offset for optimal first layer adhesion.

What to Look For:

Correct offset:
Smooth, even surface. Lines fully fused. Slight gloss. Thickness close to 0.2 mm.

Too low (nozzle too close):
Matte, rough surface. Filament squished or missing. Possible nozzle clog.

Too high (nozzle too far):
Gaps between lines. Poor adhesion. Uneven texture. Corners may lift.

How to Adjust Z-offset:

Lower offset (more negative) → nozzle moves closer

Raise offset (less negative) → nozzle moves away

Example:
-1.95 = lower nozzle
-1.85 = higher nozzle

Goal:
Print should be thin(0.20mm thickness), well-adhered, smooth to the touch, and measure close to 0.2 mm.

Tagi