Z offset First layer test calibration eneagon print 50mm, 75mm, 100mm and all corners for 0.2mm layer height
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
First layer test to adjust z offset for perfect first layer for 0.2mm layer height
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 139
- Makes
- 0
- Views
- 333
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- GNU General Public License v2.0
This test model matches a standard first layer height (0.2 mm) and helps fine-tune your Z-offset for optimal first layer adhesion.
What to Look For:
Correct offset:
Smooth, even surface. Lines fully fused. Slight gloss. Thickness close to 0.2 mm.
Too low (nozzle too close):
Matte, rough surface. Filament squished or missing. Possible nozzle clog.
Too high (nozzle too far):
Gaps between lines. Poor adhesion. Uneven texture. Corners may lift.
How to Adjust Z-offset:
Lower offset (more negative) → nozzle moves closer
Raise offset (less negative) → nozzle moves away
Example:
-1.95 = lower nozzle
-1.85 = higher nozzle
Goal:
Print should be thin(0.20mm thickness), well-adhered, smooth to the touch, and measure close to 0.2 mm.