1 / 3
Ryobi RTS12T Table Saw Stand, Clip-On Bolt Holder or a standalone small box — zdjęcie 1
1 / 3

Ryobi RTS12T Table Saw Stand, Clip-On Bolt Holder or a standalone small box

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

If you are not using the stand with the saw, this is a clip-on holder for the bolts and wing nuts.

Ocena
0 / 5
Polubienia
0
Pobrania
9
Wydruki
0
Wyświetlenia
69
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution

This clips onto the horizontal pole under the saw. The clip fits a 19.5mm diameter. Since the clip is screwed on, the box can be used stand alone or a clip made of your own design or other type of mount. Inside box dimensions are 14mm x 52mm x 52mm. The slide lid will squish on the build plate making a very tight fit. The sides will need to be slightly trimmed for a good fit. If you trim too much, slightly pinch a couple of places on the sides with small needle nose pliers or similar. The 3mm nut press fits into the clip. I used needle nose pliers to insert the 8mm buttonhead screw inside the box and screwed the clip into it. The hole on the other side of the box is for the 2mm hex wrench to tighten the screw to the clip.

Generic black PLA & 3D Fuel LulzBot green PLA, General PLA settings work fine.