1 / 3
Ryobi RTS12T Table Saw Stand, Clip-On Bolt Holder or a standalone small box — image 1
1 / 3

Ryobi RTS12T Table Saw Stand, Clip-On Bolt Holder or a standalone small box

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

If you are not using the stand with the saw, this is a clip-on holder for the bolts and wing nuts.

Rating
0 / 5
Likes
0
Downloads
9
Makes
0
Views
69
Reviews
0

Updated at source:

Model information

Category
Organizers
License
Creative Commons — Attribution

This clips onto the horizontal pole under the saw. The clip fits a 19.5mm diameter. Since the clip is screwed on, the box can be used stand alone or a clip made of your own design or other type of mount. Inside box dimensions are 14mm x 52mm x 52mm. The slide lid will squish on the build plate making a very tight fit. The sides will need to be slightly trimmed for a good fit. If you trim too much, slightly pinch a couple of places on the sides with small needle nose pliers or similar. The 3mm nut press fits into the clip. I used needle nose pliers to insert the 8mm buttonhead screw inside the box and screwed the clip into it. The hole on the other side of the box is for the 2mm hex wrench to tighten the screw to the clip.

Generic black PLA & 3D Fuel LulzBot green PLA, General PLA settings work fine.