Slatwall DeWALT Battery Charger Hanger DCB112 and DCB115
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This Slatwall hanger for a DeWALT Charger uses 4-inch hooks for mounting, see the hookhybridslatwall tag for more.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 587
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Like the rest of the Slatwall models I am releasing with the ‘hookhybridslatwall’ tag, this hanger for a DeWALT Battery Charger clicks together with a couple cheap 4-inch metal hooks to avoid having a printed plastic part in the key structural section of the part.
This will probably work with any DeWALT charger, but I have added a file for the two I own:
- DCB112 → 4mm spacing between standoff feet and back plate
- DCB115 → 6.5mm spacing between standoff feet and back plate
You might have to pull the hooks back out of the part a little bit to get enough clearance to slip them under the slatwall slat, but this should have a nice firm hold after that.
The specific hooks I ordered are here, but likely any 4-inch hooks with approx 4.0-4.3mm diameter rods should work here.
- (optional) If you have a different brand of hooks with bad tolerances, consider adding some extra bend to the hook tip angle so it better matches the tip angle at the end of the channel halfpipes
- Insert the hooks through the elongated holes at the back of the hanger with the hook tips pointing down
- Push the hooks through the part until the hook plate is flush with the back of the hanger
- Rotate the hooks about the rod axis until the hooks are pointing ‘up’, and the hook clicks into the halfpipe channel securely
I am using ‘Proslat’ brand slatwalls here (the cheapest PVC version), but any slatwall should work fine with the offbrand hooks regardless.
This part is least risky to print with the back facing downwards (as the model is uploaded), it should not require supports if your bridging is decent.
If you add supports, make sure they are only from the build plate to avoid mucking up the ziptie channels.
You can bend the top of the cheap hook plates forward for a firmer hold on the slatwall (see image).
You can use up to an m5 countersink bolt to attach the part to the charger, or push a ziptie down each of the posts from the back (see image for installed ziptie). For the zipties you need to drill a small hole in the side of each standoff on the charger around 15 degrees towards the center so it aligns with the ziptie holes (see image).
The channel down the back is for the cord.
Printed with a 0.8 nozzle and 0.32 Z-heights