Pony pipe clamp stands
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stands for Pony pipe clamps to prevent them falling over.
- Ocena
- 4,75 / 5
- Polubienia
- 103
- Pobrania
- 355
- Wydruki
- 4
- Wyświetlenia
- 1553
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The stands prevent Popy Jorgensen pipe clamps from falling over constantly. They also elevate the clamps slightly.
Part A keeps the clamps upright and must be placed on the screw side. Part B is the end support and can be placed anywhere along the pipe near the sliding end.
The stands are used with the ¾ inch (20mm) pipe clamp fixture.
Printing tips
Take note of print orientation and support in images - prints must lay down flat on the print bed.
Supports: paint supports only on bottom of protrusion for Part A and use normal supports (not tree) for smoother result. Part B doesn't need supports.
First layer and top surface: 0.36mm
Infill: Cubic 15%
Printed in PETG, but PLA will also work. Watch out for too much layer cooling to prevent warping.