Pony pipe clamp stands
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Stands for Pony pipe clamps to prevent them falling over.
- Rating
- 4.75 / 5
- Likes
- 103
- Downloads
- 355
- Makes
- 4
- Views
- 1,553
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The stands prevent Popy Jorgensen pipe clamps from falling over constantly. They also elevate the clamps slightly.
Part A keeps the clamps upright and must be placed on the screw side. Part B is the end support and can be placed anywhere along the pipe near the sliding end.
The stands are used with the ¾ inch (20mm) pipe clamp fixture.
Printing tips
Take note of print orientation and support in images - prints must lay down flat on the print bed.
Supports: paint supports only on bottom of protrusion for Part A and use normal supports (not tree) for smoother result. Part B doesn't need supports.
First layer and top surface: 0.36mm
Infill: Cubic 15%
Printed in PETG, but PLA will also work. Watch out for too much layer cooling to prevent warping.