Mouse Clutch Fidget Toy
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A fidget toy that uses a one-way "mouse" clutch.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 244
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a fidget toy version of a one-way clutch. It's designed to be unenclosed so the clutch mechanism is visible.
Warning: this can be super annoying.
In addition to the printable parts, you'll need:
- a short length of 3mm rod for the main axle (about 60mm)
- 2x M3 set screws (length doesn't really matter, I used 3mm)
You might be able to get away without the set screws by press fitting the parts to the axle - it'll depend on your printer settings. If too loose, perhaps try using slicer hole compensation or scale it down a bit. Or use slightly larger axle rod (eg: 1/8" rod is just over 3mm).
The pawls and sync ring are print-in-place, so you'll need a well calibrated printed.
Reddit discussions here: