WinWing FCU +/- EFIS Desk Mount Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stand to mount WinWing FCU (with or without EFIS) to a desk/board (or can stand on its own). Lifts panel off desk too...
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 138
- Wydruki
- 0
- Wyświetlenia
- 800
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you own the WinWing FCU (with or without the EFIS panels on the side) you know that the WinWing stands that come with it are hardly stable for desk use (fine for mounting on a sim-pit rail). So I made stands that bolt on the same place (I used the inner holes on the EFIS panels) to hold the unit, it stands on its own, but has screws on the base to hold it about an inch (2.5cm) above the desk. It takes up-to drywall screws to hold it to the surface (I'd took a board that then sits on the desk rather than screwing into your desk, but you-do-you). Anyway, I printed these in ASA that nicely matches the WinWing black plastic. I did 4 perimeters and 25% hex infill and they are solid. They print without supports (just lay them on the flat side) and I gave larger slots than the WinWing stands to let you move them around as needed. Use the WinWing M5 bolts with washers that came with the unit. As always I included the STEP files in case you want to change them in anyway (and you can of course print the STEPs directly or use the 3MF files).