1 / 4
Bottle stand (for e.g Pril) / Flaschenhalter (für z.B. Pril) — zdjęcie 1
1 / 4

Bottle stand (for e.g Pril) / Flaschenhalter (für z.B. Pril)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Pril bottle holder – for complete emptying without leaks. Pril-Flaschenhalter – für restlose Entleerung ohne Auslaufen.

Ocena
5 / 5
Polubienia
49
Pobrania
162
Wydruki
2
Wyświetlenia
936
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

(deutsche Beschreibung weiter unten)


This 3D-printed bottle holder is specifically designed for dish soap bottles such as Pril, with a focus on practical, complete emptying. The bottle is placed upside down in the holder so that the cap seals tightly. The base of the holder is fully enclosed to prevent any leaks – even if the cap isn’t 100% tight.

Its shape is tailored precisely to fit Pril bottles, ensuring a secure and upright position.

The design is compact, stable, and easy to print – no support material required.

Printing recommendations:

Material: any of your choice (e.g., PLA, PETG, ABS)

Infill: approx. 15%

Supports: not needed

Layer height:  0.2 mm

Post-processing: not required

Pril is a registered trademark of Henkel. This product is not affiliated with or endorsed by Henkel.


------------------


Dieser 3D-gedruckte Flaschenhalter ist speziell für Spülmittelflaschen wie z. B. Pril entworfen – mit Fokus auf praktischer Restentleerung. Die Flasche wird kopfüber in den Halter gestellt, sodass der Verschluss fest schließt. Der Boden des Halters ist vollständig geschlossen, damit kein Tropfen ausläuft – selbst wenn die Flasche nicht ganz dicht wäre.

Durch seine Form passt er exakt auf Pril-Flaschen und sorgt für sicheren, aufrechten Stand.

Das Design ist kompakt, stabil und einfach zu drucken – ohne Stützmaterial.

Druckempfehlung:
– Material: frei wählbar (z. B. PLA, PETG, ABS)
– Infill:  15 %
– Stützstruktur: nicht notwendig
– Schichthöhe:  0,2 mm
– Kein Nachbearbeiten erforderlich

Pril ist eine eingetragene Marke der Henkel AG. Dieses Produkt steht in keiner Verbindung zu Henkel.

Tagi