Apex Seals for Kocyns Wankel Engine
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two sets of Apex Seals for Kocyns' Wankel Engine from MakerWorld
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 77
- Wydruki
- 1
- Wyświetlenia
- 298
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
Disclaimer
I haven't printed the whole engine yet so fitment is not guaranteed. Models may get updated down the Line
~July 15th 2025
After scrolling through the comment section of Kocyns Wankel Engine I stumbled upon a commenter who modeled themselves some Apex Seals but didn't release the model publicly.
So I modeled some myself.
The Last Picture is supposed to show the overlap/extension between the spring and the basic seal
Print the Rotors first, then a Test Piece to check for clearances, as demonstrated here
Print Settings:
Layer Height: 0.20mm
Walls: 3
Top/Bottom Layers: 3
Elephants Foot Compensation : 0.25 (optional for clearance)
Material: PETG or similar toughness (bendable)
To work it needs to be round or at least square. Adjust your Z-Offset and First Layer Width if necessary
Printed on an Elegoo Centauri Carbon