Apex Seals for Kocyns Wankel Engine
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two sets of Apex Seals for Kocyns' Wankel Engine from MakerWorld
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 77
- Makes
- 1
- Views
- 298
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
Disclaimer
I haven't printed the whole engine yet so fitment is not guaranteed. Models may get updated down the Line
~July 15th 2025
After scrolling through the comment section of Kocyns Wankel Engine I stumbled upon a commenter who modeled themselves some Apex Seals but didn't release the model publicly.
So I modeled some myself.
The Last Picture is supposed to show the overlap/extension between the spring and the basic seal
Print the Rotors first, then a Test Piece to check for clearances, as demonstrated here
Print Settings:
Layer Height: 0.20mm
Walls: 3
Top/Bottom Layers: 3
Elephants Foot Compensation : 0.25 (optional for clearance)
Material: PETG or similar toughness (bendable)
To work it needs to be round or at least square. Adjust your Z-Offset and First Layer Width if necessary
Printed on an Elegoo Centauri Carbon