1 / 3
VGA watercooler (Asrock RX 570 8G) — zdjęcie 1
1 / 3

VGA watercooler (Asrock RX 570 8G)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3d printed watercooler block for Asrock RX570 8G only.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
73
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

Water cooling block for the Asrock RX 570 8G video card. You need a few more screws, soft silicone cord for sealing, and the usual fittings. The heat sinks are copper plates, there is a special plate under the GPU (from a cheap water cooling block from Ali) .  (The VRM cooling also needs to be taken care of, I simply soldered a copper plate and a copper tube together and connected it to the water circuit.) I recommend making the modells with a resin printer, because it is really difficult to print airtight models with an FDM printer. I ended up printing a mold from TPU and casting the model out of epoxy resin. Before installing it on the video card, be sure to check for leaks. Use at least a 240mm radiator and you will gain 20-25 degrees in addition to the silence...good luck!