VGA watercooler (Asrock RX 570 8G)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3d printed watercooler block for Asrock RX570 8G only.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 5
- Makes
- 0
- Views
- 73
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
Water cooling block for the Asrock RX 570 8G video card. You need a few more screws, soft silicone cord for sealing, and the usual fittings. The heat sinks are copper plates, there is a special plate under the GPU (from a cheap water cooling block from Ali) . (The VRM cooling also needs to be taken care of, I simply soldered a copper plate and a copper tube together and connected it to the water circuit.) I recommend making the modells with a resin printer, because it is really difficult to print airtight models with an FDM printer. I ended up printing a mold from TPU and casting the model out of epoxy resin. Before installing it on the video card, be sure to check for leaks. Use at least a 240mm radiator and you will gain 20-25 degrees in addition to the silence...good luck!