Tablet Stand (Obsolete: former LabQuest 3 Stackable Stand, Underhand V1)

This is a general stand that can be repurposed as a stand for a tablet with only one single position (or a very oversized stand for a smartphone).

This was formerly titled “LabQuest 3 Stackable Stand (Underhand Variant) V1”.  This is no longer being used for that purpose and is considered obselete (i.e., don't use anymore), as the front shelf was too short to properly hold the LabQuest 3 device.  There was a short period of time where I had no access to the device itself, so this entry here should be a document on poor practices that should be avoided during the 3D designing and printing process.  Due to this, this stand is also too wide to fit the LabQuest device.

Also, after the V1 revision of my LabQuest 3 stand project, I decided that this would be the last Underhand variant of the stand, as it turned out that knowing the exact front shelf length was ultimately crucial to making a successful stand.

----------

Below is the original description:

Inspired by this stackable phone stand from MakerWorld and the LabQuest 3 Stand from @PhysicsGuy288633, I used my Underhand variant of my phone stand to make a stand for the Vernier LabQuest 3 device by making the model slightly thicker (3mm) and wider (150mm, which is almost 6 inches wide).

While the model from @PhysicsGuy288633 did the job for holding up the LabQuest 3 device, there was an additional request to our club for the stand to be stackable.  So, I took inspiration from the MakerWorld stand to make a stackable stand for the LabQuest 3.