1 / 1
Metal Shocks for 1:16 Truck/Crawler 4x4 RC Chassis — zdjęcie 1

Metal Shocks for 1:16 Truck/Crawler 4x4 RC Chassis

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This modifications allows for metal shocks to be added to the 1:16 Truck/Crawler4x4 RC Chassis model

Ocena
5 / 5
Polubienia
29
Pobrania
101
Wydruki
0
Wyświetlenia
1311
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Working on my latest RC build, I realized off-the-shelf suspension shocks were surprisingly affordable. To bridge that gap, I designed these 3D printable adapters for them.

Required Products

Print Settings

General Print Settings for all the .stl files:

  • Print either frame-brace-metalshocks_x2.stl (if you are using the printed frame) or frame-rear-metalshocks_x2.stl (if you are using a bought metal frame)

  • Print in the amounts indicated at the end of the filename

  • 0.15mm layer height

  • 4 perimeters, 30% infill

  • PLA or PETG (tested both)

  • All files should be printed in the orientation they come with

  • Supports required for axle-truss-metalshocks_x2.stl only

  • Brim recommended for frame-front-metalshocks_x2.stl

Assembly

 

  1. Use four M2.3x6mm to secure frame-brace-metalshocks_x2.stl to the rear of the frame:
     


     

  2. Use two M2.5x14mm screws (short screws that comes with the kit) to secure the metal shocks to the adapter (do not over-fasten):


     

  3. Use two M2.3x6mm screws to secure frame-front-metalshocks_x2.stl to the front of the frame:


     

  4. Use two M2.5x14mm screws (short screws that comes with the kit) to secure the metal shocks to the adapter:
     


     

  5. Secure metal shocks to axle-truss-metalshocks_x2.stl using the four M2.5x12mm screws (do not over-fasten) and axle-truss-washer_x4.stl: