Metal Shocks for 1:16 Truck/Crawler 4x4 RC Chassis
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This modifications allows for metal shocks to be added to the 1:16 Truck/Crawler4x4 RC Chassis model
- Rating
- 5 / 5
- Likes
- 29
- Downloads
- 102
- Makes
- 0
- Views
- 1,321
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Working on my latest RC build, I realized off-the-shelf suspension shocks were surprisingly affordable. To bridge that gap, I designed these 3D printable adapters for them.
Required Products
Print Settings
General Print Settings for all the .stl files:
Print either frame-brace-metalshocks_x2.stl (if you are using the printed frame) or frame-rear-metalshocks_x2.stl (if you are using a bought metal frame)
Print in the amounts indicated at the end of the filename
0.15mm layer height
4 perimeters, 30% infill
PLA or PETG (tested both)
All files should be printed in the orientation they come with
Supports required for axle-truss-metalshocks_x2.stl only
Brim recommended for frame-front-metalshocks_x2.stl
Assembly
Use four M2.3x6mm to secure frame-brace-metalshocks_x2.stl to the rear of the frame:

Use two M2.5x14mm screws (short screws that comes with the kit) to secure the metal shocks to the adapter (do not over-fasten):

Use two M2.3x6mm screws to secure frame-front-metalshocks_x2.stl to the front of the frame:

Use two M2.5x14mm screws (short screws that comes with the kit) to secure the metal shocks to the adapter:

Secure metal shocks to axle-truss-metalshocks_x2.stl using the four M2.5x12mm screws (do not over-fasten) and axle-truss-washer_x4.stl:
