1 / 5
Fishing Rod Holder for Yeti Hitchpoint, Molle, and gear with 1" straps — zdjęcie 1
1 / 5

Fishing Rod Holder for Yeti Hitchpoint, Molle, and gear with 1" straps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple Fishing Rod Holder for Yeti Hitchpoint, Molle, and gear with 1" straps

Ocena
0 / 5
Polubienia
15
Pobrania
53
Wydruki
0
Wyświetlenia
439
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a tubular TPU holder, for fishing rods, intended for mounting on the YetI Hitchpoint system or 1 inch Molle and nylon strap gear. Two holes in the holder allow you to use a length bungee or paracord to secure rod for carrying.  A simple bungee slider will put pressure on the rod handle inside the holder and may be wrapped around the reel or handle, on the outside, for added security. The holder has an inner diameter of 51mm and should accept most fishing rods with open or closed face reels. Attaching this to the straps is most easily achieved by using needle-nosed pliers to hold the mounting “arms” and a small probe of some sort to lift the straps loops over the arms ends.  Again, I designed this for TPU. I do not know how difficult this may be to mount if printed in a rigid filament. Note: The reel notch in the model has been modified from my original version shown in the photos.

Tagi