Fishing Rod Holder for Yeti Hitchpoint, Molle, and gear with 1" straps
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple Fishing Rod Holder for Yeti Hitchpoint, Molle, and gear with 1" straps
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 53
- Makes
- 0
- Views
- 439
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a tubular TPU holder, for fishing rods, intended for mounting on the YetI Hitchpoint system or 1 inch Molle and nylon strap gear. Two holes in the holder allow you to use a length bungee or paracord to secure rod for carrying. A simple bungee slider will put pressure on the rod handle inside the holder and may be wrapped around the reel or handle, on the outside, for added security. The holder has an inner diameter of 51mm and should accept most fishing rods with open or closed face reels. Attaching this to the straps is most easily achieved by using needle-nosed pliers to hold the mounting “arms” and a small probe of some sort to lift the straps loops over the arms ends. Again, I designed this for TPU. I do not know how difficult this may be to mount if printed in a rigid filament. Note: The reel notch in the model has been modified from my original version shown in the photos.