Dragon Burner PINDA probe
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
(EXPERIMENTAL) Modified Dragon Burner to accommodate the PINDA probe without loosing precious build volume.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 408
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Print details
- Layer height: 0.2mm
- Infill: 10-20%
- Supports: No
- Materials: ABS
Non-printable parts
- M3 threaded insert (x2)
- M3x6 BHCS (x2)
- PINDA probe (x1)
Post processing
- Assemble the printhead as usual
- Fully thread the probe in the PINDA mount
- Attach the probe mount to the cowl body using the M3 bolts
- Mount the printhead to the x-carriage as usual
Klipper configuration
[probe]
pin: nhk:PROBE // Replace with the correct probe pin
z_offset: 1.55 // Run "PROBE_CALIBRATE" to get the correct offset
x_offset: -15
y_offset: 15[bed_mesh]
horizontal_move_z: 10
probe_count: 5
mesh_min: 15,15
mesh_max: 105,105
algorithm: bicubic
[stepper_z]
endstop_pin: probe:z_virtual_endstop
[safe_z_home]
home_xy_position: 60,60 // Home in the middle of the bed
*Depending on the fit, the printhead might collide with the railstops. To prevent this you can remove them.
*Designed and tested with the DragonFly BMO hot-end. The clearance might not fit other hot-ends
*The probe is mounted verry close to the hot-end, therefore it gets hot. The long-term effects are not clear. Use at your own risk.