Dragon Burner PINDA probe
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
(EXPERIMENTAL) Modified Dragon Burner to accommodate the PINDA probe without loosing precious build volume.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 59
- Makes
- 0
- Views
- 413
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Public Domain
Print details
- Layer height: 0.2mm
- Infill: 10-20%
- Supports: No
- Materials: ABS
Non-printable parts
- M3 threaded insert (x2)
- M3x6 BHCS (x2)
- PINDA probe (x1)
Post processing
- Assemble the printhead as usual
- Fully thread the probe in the PINDA mount
- Attach the probe mount to the cowl body using the M3 bolts
- Mount the printhead to the x-carriage as usual
Klipper configuration
[probe]
pin: nhk:PROBE // Replace with the correct probe pin
z_offset: 1.55 // Run "PROBE_CALIBRATE" to get the correct offset
x_offset: -15
y_offset: 15[bed_mesh]
horizontal_move_z: 10
probe_count: 5
mesh_min: 15,15
mesh_max: 105,105
algorithm: bicubic
[stepper_z]
endstop_pin: probe:z_virtual_endstop
[safe_z_home]
home_xy_position: 60,60 // Home in the middle of the bed
*Depending on the fit, the printhead might collide with the railstops. To prevent this you can remove them.
*Designed and tested with the DragonFly BMO hot-end. The clearance might not fit other hot-ends
*The probe is mounted verry close to the hot-end, therefore it gets hot. The long-term effects are not clear. Use at your own risk.