Modular Enclosure Exhaust With Shutoff Valve
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
New version of my exhaust parts that adds a shutoff valve while being configurable to the user's needs.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Someone had asked about designing a shutoff valve to use with my permanent exhaust parts on a different make. I decided to redesign the existing setup so that it would be modular by using connectors and separate duct pieces. The user can make any combo of parts and glue them together in an order that works for them. The valve can also be installed inline by itself between two flex ducts by adding a threaded end on both sides of the valve. I'm putting all compatible parts in this post so some of the parts might look familiar.
There is a straight "duct" piece that can be scaled up in the z-direction to give you the length you want. It is currently 1.5" long.
I assembled the valve with M3x16mm screws, washers and nuts to attach the flap to the lever and pin. There are indentations to hold the lever at full open or full closed.
I was able to print everything with no supports and no brims or rafts.
Have fun!