1 / 3
Funnel with Air Escape Vent and Optional Fill Gauge (Scalable) — zdjęcie 1
1 / 3

Funnel with Air Escape Vent and Optional Fill Gauge (Scalable)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For situations when you need to fill a container but cannot see inside to know when it's full.

Ocena
5 / 5
Polubienia
94
Pobrania
129
Wydruki
1
Wyświetlenia
1840
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I specifically designed this to help me refill my handsoap container, which looks nice but has a small opening and is opaque so when I am pouring I can not see how full the bottle is getting, leading to overfilling. Although the demonstration video uses water, this model does work with relatively viscous liquids (i.e., handsoap) too, albeit the fill rate is naturally a little slower.

Model features:

  • Air release vent to aid liquid flow
  • Optional fill gauge that can be inserted into the vent to additionally help you avoid overfilling: when the top of the gauge is flush with the top of the funnel your container is full! - this does not prevent the vent from working
  • Snug fitting lip on the fill gauge presents it from falling back through the vent once assembled
  • Scalable! This version is relatively small (16mm spout diameter). The design will work better the bigger it is, so for best results, scale the parts as big as you can for the opening of the container for which you want to use it.
  • Easy to print - no supports needed; prints in two parts; you can include a brim on the fill gauge if you are worried about bed adhesion
  • Easy to assemble - fill gauge can be pushed through the smaller section of the funnel spout (air vent) with some light pressure, no tools/hardware required!

The trick, when it comes to printing these models, is in making the fill gauge light and buoyant enough to float. I achieved this using PETG with .12mm layers (the layer lines at .2mm caused some friction in the slide mechanism) and some variable height settings for wall loops/infill:

  • 0-41.5mm: 2 wall loops, 1% cross hatch infill
  • 41.5-42.5mm: 100% infill (to create a seal on the top of the ‘float’ at the bottom where it meets the stem)
  • 42.5-top: 1 wall loop, no infill

There are probably lots of combinations of settings that would work, so if you make this work with different settings let me know how you did it! With scaled up versions of the model, making the fill gauge float will be more forgiving with high volume-surface area ratios.

Designed in Onshape (beware, the design process for this one is messy):

https://cad.onshape.com/documents/d5e296e853464e28058ba349/w/5941c79c9a9ce9fde5767547/e/ceebcf2431ec1da3cb460ec7?renderMode=0&uiState=6879689b27efa05cb05a0660

Tagi