1 / 2
L114 Lanyard Enclosure for the Heltec T114 v2 — zdjęcie 1
1 / 2

L114 Lanyard Enclosure for the Heltec T114 v2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An enclosure for the Heltec T114 v2 for you to hang it on a backpack, bag, or set of keys.

Ocena
4 / 5
Polubienia
50
Pobrania
221
Wydruki
1
Wyświetlenia
2074
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a case for the Heltec T114 V2 for you to dangle on a bag, backpack, or set of keys as a neat “charm”. It includes space for a GPS module, as well as a RAK PCB antenna or OEM coil antenna.

Materials Required

Printing Instructions

  • Print for strength settings in whatever material you prefer.
  • Place the face of the main case facing the print bed
  • Place the back of the cover facing the print bed
  • Enable thin wall detection

Assembly Instructions

  1. Connect the GPS module, antenna, and battery to the T114 v2.
  2. Place the T114v2 port-first into the case. Gently snap into place, ensuring the board is laying flat.
  3. Place the antenna into the case above the T114v2. Carefully “fold up” the antenna wire if you have to, but no sharp bends!
  4. Place the GPS module and shimmy it into place, avoiding the geometry where the M3 screw will go through.
  5. Place the back cover on the case. You can slightly bend it to get it to snap into place. Secure with an M3 x 8mm flathead screw.
  6. Attach a carabiner, hook to a bag, and enjoy!

Tagi