1 / 2
L114 Lanyard Enclosure for the Heltec T114 v2
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An enclosure for the Heltec T114 v2 for you to hang it on a backpack, bag, or set of keys.
- Rating
- 4 / 5
- Likes
- 50
- Downloads
- 221
- Makes
- 1
- Views
- 2,074
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case for the Heltec T114 V2 for you to dangle on a bag, backpack, or set of keys as a neat “charm”. It includes space for a GPS module, as well as a RAK PCB antenna or OEM coil antenna.
Materials Required
- Heltec T114 V2 nEF52840 (Amazon - affiliate link)
- + GPS Module and cable (included in link above)
- 1x M3 x 8mm Flat Head Screw (Amazon - affiliate link)
- 1x 502030 LiPo Battery 3.7v w/ MICRO-JST CONNECTOR (Amazon - affiliate link)
- 1x RAK PCB 915mHz antenna or OEM coil antenna
- (optional) Spigen Quick Release Keychain (Amazon - affiliate link) or a carabiner of your choice
Printing Instructions
- Print for strength settings in whatever material you prefer.
- Place the face of the main case facing the print bed
- Place the back of the cover facing the print bed
- Enable thin wall detection
Assembly Instructions
- Connect the GPS module, antenna, and battery to the T114 v2.
- Place the T114v2 port-first into the case. Gently snap into place, ensuring the board is laying flat.
- Place the antenna into the case above the T114v2. Carefully “fold up” the antenna wire if you have to, but no sharp bends!
- Place the GPS module and shimmy it into place, avoiding the geometry where the M3 screw will go through.
- Place the back cover on the case. You can slightly bend it to get it to snap into place. Secure with an M3 x 8mm flathead screw.
- Attach a carabiner, hook to a bag, and enjoy!