DJI O4 Lite 19mm Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a little spacer (printed out of TPU) that allows the DJI O4 Air Unit “Lite” to fit into frames that have…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 103
- Wydruki
- 0
- Wyświetlenia
- 279
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a little spacer (printed out of TPU) that allows the DJI O4 Air Unit “Lite” to fit into frames that have spacing for a 19mm camera. It also allows for a small amount of vibration absorption since it's not very rigid.
I used the included M2 (ish) screws to hold this to the camera. These were “low profile” enough to not hit the frame thankfully. Then I then a M2x4 to attach this to the frame. The holes are slightly undersized and seem to hold the camera just fine.
Print Settings
Printer Brand:
Bambu Lab
Printer:
Bambu X1C
Rafts:
No
Supports:
No
Resolution:
.16
Filament Material:
TPU
Notes:
Designed to be printed with TPU, although any other would probably work. TPU will provide a little bit of vibration absorption.
Category: R/C Vehicles