Battlestar Galactica Logo Wall or Desk Decoration-4-1/2" (112mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Same piece can either sit on a table top or hang on the wall
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The old school Battlestar Galactica logo with the “angel” lady on it. It looks great because I put the flowing parts of her dress at different heights to give depth.It is about 4-½" (112mm) diameter.
There is a foot that fits into the back for stability. The bottom is also angled a bit so it tilts back a little on the table top and doesn't want to tip forward all the time.
There is also a screw/nail hole in the back if you wanted to hang it on a wall.
Change the filament at 17.2mm for two-tone look.
I do have a larger 8" (200mm) diameter version for the wall too.
I used an old printer that I only use for test prints, so don't let the poor quality of the top layers fool you. It looks great on a good printer.