1 / 3
Prusa CORE One Sheet Holder (2mm x 5mm x 20mm Magnets) — zdjęcie 1
1 / 3

Prusa CORE One Sheet Holder (2mm x 5mm x 20mm Magnets)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple sheet holder for the Prusa CORE One

Ocena
5 / 5
Polubienia
39
Pobrania
248
Wydruki
7
Wyświetlenia
1389
Oceny
8

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Requires (8) 2mm x 5mm x 20mm magnets

I printed it in Prusament PETG Prusa Orange with these Prusa Slicer settings: 0.20 Structural, 3 perimeters, 50% infill, and supports on the build plate.  I recommend printing it upright (as pictured) with supports which will create a little ramp of support material underneath because the bottom of the model has a slight downward slope to match the CORE One's profile.  It'll take a few minutes to clean off the supports when done, but will print perfectly and the layer lines will be parallel to your table.

Holds 3 Prusa sheets.

I designed this after trying one sheet holder on Printables that was full length (which seems wasteful) but found that it was too short and had slots that were too wide - making the sheets lay on each other and touch the Core ONE frame.

***Version 2 - Published Jan 1, 2026***

Version 2 has 1 slot that is 1.5mm wide for a Prusa Smooth sheet and 2 slots that are 0.9mm wide for Prusa Textured and Prusa Satin sheets.

Version 1 has 3 slots that are all 1.5mm wide.  This size is good for Prusa Smooth sheet, but a bit wide for the Textured and Satin sheets.

Tagi