1 / 3
Prusa CORE One Sheet Holder (2mm x 5mm x 20mm Magnets) — image 1
1 / 3

Prusa CORE One Sheet Holder (2mm x 5mm x 20mm Magnets)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple sheet holder for the Prusa CORE One

Rating
5 / 5
Likes
39
Downloads
248
Makes
7
Views
1,389
Reviews
8

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial

Requires (8) 2mm x 5mm x 20mm magnets

I printed it in Prusament PETG Prusa Orange with these Prusa Slicer settings: 0.20 Structural, 3 perimeters, 50% infill, and supports on the build plate.  I recommend printing it upright (as pictured) with supports which will create a little ramp of support material underneath because the bottom of the model has a slight downward slope to match the CORE One's profile.  It'll take a few minutes to clean off the supports when done, but will print perfectly and the layer lines will be parallel to your table.

Holds 3 Prusa sheets.

I designed this after trying one sheet holder on Printables that was full length (which seems wasteful) but found that it was too short and had slots that were too wide - making the sheets lay on each other and touch the Core ONE frame.

***Version 2 - Published Jan 1, 2026***

Version 2 has 1 slot that is 1.5mm wide for a Prusa Smooth sheet and 2 slots that are 0.9mm wide for Prusa Textured and Prusa Satin sheets.

Version 1 has 3 slots that are all 1.5mm wide.  This size is good for Prusa Smooth sheet, but a bit wide for the Textured and Satin sheets.

Tags