Flash adapter with pogo test pins for WLED ESP32 Controller

Flash adapter with pogo test pins for up to 6 pins.

This model is mainly used for the WLED ESP32 Controller:

https://github.com/Hasenpups/WLED_ESP32_Controller

The following parts are required:

3D prints
1 x M3x30 screw
2 x M3x 10 screw
1 x 8mm spring 20mm long
1 x jumper wire (1x4 Pins)
4 x 1mm Pogo Pins

The M3 threads are modeled in the design and will be printed, there is no need to cut the threads.

Attention, there is also a thread in all 3 blocks of the base. This way there is no nut required.

The pogo pins need to be gently pressed into the holes of the female jumper wires.