Vertical Tail FPV Pod for Eclipson Hushwing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This allows you to attach Caddx Ant Nano camera and HGLRC Zeus Nano VTX to vertical tail of Eclipson Helix or similar
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed for Eclipson Hushwing, but should fit many similarly sized models.
Fits Caddx Ant Nano camera, HGLRC Zeus Nano FPV transmitter and maximum 4.5 mm diameter antenna for cheap (~$35) and lightweight (~10 g) FPV setup.
The camera is held back by VTX, which itself is just pressed against the tail surface. Antenna is press-fit. There's not much space inside, so remove all screw holes from VTX, keep all wire lengths to the minimum, and preferably solder them with wires towards the middle of the board. After inserting components, glue both halves together with CA and then onto vertical tail. Power wires are intended to be run along LE of the vertical tail and along the fuselage.
Don't print in PLA as VTX might melt it if on the ground for too long. This print is rather thin, so achieving good results may need decreasing print temperature and increasing cooling and minimum time per layer.
Check out my other FPV related things and RC stuff for more cool things. Happy printing and safe flying!