UNW airsoft GBB version of: Unseenkiller DP17 PY2A
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
should be as simple as dropping in the parts
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 285
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
12-10-2025
models are updated so that the slide lock cant be pushed outwards. what causes extra slide ware
this can be fixed with a 0.6mm spacer if you want to update a printed frame
-
12-08-2025
updated the model so it got a bit ticker walls at the grip.
-------
29-07-2025
I have moved the mag 0.5mm up. this should be better. but this not tested with other users.
------
21-07-2025 update
I had to update the Gen 4 model so the mag release button cant fall out this was a thing that could happen based on how the original model was designed that I over looked
__
extra note on this model: I needed to make the pin hole for the front rail a bit smaller to avoid a modeling error. so I made it the correct size for so far I could. and there should be only like 1mm or 2mm that is to tight on each side.
--
just a cosmetic chance to the lower in this case styled after a design made by UNSEENKILLER
compatibility note:
WE-tech G series 17 and 18 from gen 3 up to gen 4 (5 will be added later)
TM G series 17 gen3: fits
AW VX7 and VX8 : should fit the Gen 3 version but this is not tested
G-force 17 : should fit the Gen 4 version but this is not tested
Nuprol: Raven / Vorsk EU7, EU8 is most likely compatible and should be used with the gen4 version
assembly note:
you might want to look up some videos in case your new to disabling this model of GBB. but it should be same as dissembling and assembling a official one