UNW airsoft GBB version of: Unseenkiller DP17 PY2A
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
should be as simple as dropping in the parts
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 56
- Makes
- 0
- Views
- 285
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
12-10-2025
models are updated so that the slide lock cant be pushed outwards. what causes extra slide ware
this can be fixed with a 0.6mm spacer if you want to update a printed frame
-
12-08-2025
updated the model so it got a bit ticker walls at the grip.
-------
29-07-2025
I have moved the mag 0.5mm up. this should be better. but this not tested with other users.
------
21-07-2025 update
I had to update the Gen 4 model so the mag release button cant fall out this was a thing that could happen based on how the original model was designed that I over looked
__
extra note on this model: I needed to make the pin hole for the front rail a bit smaller to avoid a modeling error. so I made it the correct size for so far I could. and there should be only like 1mm or 2mm that is to tight on each side.
--
just a cosmetic chance to the lower in this case styled after a design made by UNSEENKILLER
compatibility note:
WE-tech G series 17 and 18 from gen 3 up to gen 4 (5 will be added later)
TM G series 17 gen3: fits
AW VX7 and VX8 : should fit the Gen 3 version but this is not tested
G-force 17 : should fit the Gen 4 version but this is not tested
Nuprol: Raven / Vorsk EU7, EU8 is most likely compatible and should be used with the gen4 version
assembly note:
you might want to look up some videos in case your new to disabling this model of GBB. but it should be same as dissembling and assembling a official one